TP-Link - Deco BE63 BE10000 Whole Home Mesh WiFi 7 System

+1 for the Decos. (Decoes?) They've been pretty reliable over the year and a half-ish that I've had them. The app is a bit funky (esp for more advanced stuff), but as far as being a router, they seem great.

I highly recommend the [TP-Link Wi-Fi 7 Tri-Band Mesh System](https://www.reddit.com/user/unwelcome_frown15/comments/1jxaza0/mesh_wifi_system_recommendations/). It offers blazing fast speeds, low latency, and rock-solid coverage, great for large homes or demanding smart setups. Future-proof too with Wi-Fi 7 support.

TP-Link Deco work quite well, I've installed plenty of them. Even with wireless backhaul they cope well.

I used the deco mesh system in the end. Honestly I really like it, I have only had a few minor hiccups but the control I have is great and it was easy to set up. It also helped I got them $100 off

Deco. Asus has done me dirty too many times to EVER buy something from them again. Don't warranty me twice. Get out of my house.

Even the mid range TP-Link mesh stuff goes well for your average home user with a couple of 4k TV's and a console plus phones and kids.

The wireless backhaul is nothing to sniff at on the better domestic mesh systems. I've got a higher end orbi system, and move an absolute boatload of data around, with more than 50 attached devices on the network, and it holds up very, very well. Your average home user will be well served by a Deco mesh.

Re-iterating what others have stated. They work great when you hardware each unit. I am not a fan of wireless backhaul. In theory it should work, but in reality I find them lacking. I have recently done a Deco install and an Eero install, hardwiring all units for both. It is sometimes cheaper to do it this way than buying APs to wire in. Just remember to have the "Main" mesh unit first in the chain. I usually go Internet Modem -> First Mesh Unit -> switch -> satellites.

7,299 right now on Amazon for 3 unit TP link deco.

Buy 2 unit mesh for 5k and check coverage. Then add more if necessary.

I use a deco. I had disconnection problems when I was using the fast band and I saw someone recommended that Google home prioritize consistency over speed and that I should switch over to 2.4hz. I did that and my Google home has never had a disconnect since.